wooden board/wooden case/straw rope for paper machine manufacturers

1. High quality corrugated paper making machine Technical parameter: 

1.Raw material: recyled paper, waste carton box, wood pulp, cotton straw, wheat straw, sugar cane bagasse

2.Output paper: kraft paper,corrugated paper, fluting paper, testliner paper 

3.Net paper width: 2100mm

4.Width of cylinder mould: 3300mm

5.Capacity: 80t/d

6.Working speed: 150-200m/min

7.Rail gauge: 3900mm

8.Drive way: Alternating current ,frequency converter, speed control ,section drive

2. high quality corrugated paper /kraft paper/testliner making machine structure and characteristic of main part:

1. Cylinder section: φ 1250mm•2450mm stainless steel cylinder mould 1 set, φ 450mm× 2450mm couch roll 1 set, φ 400× 2450mm reverse roll 1set, coated by rubber, rubber shore hardness 38 ± 2. 
2. Press section: φ 500mm× 2450mm marble roll 1 set, φ 450mm× 2450mm rubber roll 1 set, coated by rubber, rubber shore hardness 90 ± 2. 
3. Dryer section: φ 1500mm× 2450mm cast iron dryer can1 set, φ 500mm× 2450mm touch roll 1 set, coated by rubber, rubber shore hardness 90 ± 2. 
4. Drive way: Alternating current, frequency conversion, speed control, section drive.

3. high quality corrugated paper making machine Main equipments of kraft paper machine

 4. high quality corrugated paper making machine pictures about our brown packing paper making machine: 

  5. high quality kraft paper, corrugated paper, testliner paper making machine main making part:

5.1. Fourdrinier forming section mainly consists of wire table rack, walking board, white water tray, forming board, dewatering plate, wet absorb box, suction box, breast roll support up and down, vacuum couch, wire driving roll, wire leading roll, scraper, spray pipe, paper edge cutting paper leading squirt cut, wire tight device, corrector and so on.5.2. The main function of the Paper Machine Press section is to continue to remove water from the pulp fibers and to smooth the surface characteristics of the felt and wire sides (top and bottom sides) of the paper web running the length of the machine. The dewatering is carried out by a mechanical pressing of the paper layer against properly selected felts. The simplest construction of a pressing nip consists of two rotating rolls with the paper-felt sandwich transported between them at high speed. During the pressing of the paper layer against the felts, water is squeezed out of the paper and enters the felts. So the water content of the paper decreases to about 48-50% after the pressing section. 

 5.5. PAPER RECYCLING SAVES:

• Energy:It takes 64% less energy to make paper from recycled ma
  terials (used paper) than from virgin fiber (trees).
  Recycling one ton of paper saves the equivalent of
  70 gallons of gasoline or 3 barrels of oil.
  Water:It takes 61% less water to make pape
  r from 100% recycled materials.
  Land:
  Every ton of paper recycled saves 100 cubic feet of landfill space.
  Air:Making recycled paper results in 70% fewer air
  pollutants than making paper from virgin wood.

• For every ton of paper recycled, approximately 17 trees are saved.