resolution 1 um 50-3000mm linear scale glass scale

Linear scale

1:output:+5VTTL,+12VTTL,24VTTL

2:Output signal:TTL,EIA-422-A (RS-422)~1VPP

3:Rolling system:vertical five bearing rolling system

4:Grating system transmission infrared optical measuing system the infrared wave length is 880nm

characteristic

1:high speed of movement,above 60m/min

2:bearing are adopted for sliding part to provide easy movement and excellent repeated positioning function

3:muti-layer isolating wire mesh and metal soft shell protectin is adopted for signal cable to provide excellent water-proof and anti-interrupyion performance.

4:aluminum alloy material with anodic disposal is adopted for scale head is cast with hard chrome-plating alloy of wearing resistance

5:special rubber is adopted for dust proof cover,which is of good scaping and corrsion resistance and small friction

6:individualized components makes it very easy to install,maintain and repair the linear encoder,and it is of anti-water dust-proof and long time

7:glass precision measuring grating is adopted for the linear encoder as measuring benchmark to ensure high precision

8:single light source illumination is adopted for good intergration

D60 digital readout  technical parameter

1)Voltage range: AC 80V-260V/50HZ-60HZ

2)Power dissipation: 20VA

3)Coordinate number: 1/2/3

4)Display: 7 bit display with signed

5)Times frequency: 4X

6)Readout box input signal: TTL,ELA-422-A

7)Input frequency:>100KHZ

8)Resolution:10um, 5um, 1um, 0.5um, 0.1um

9)Operating keyboard: light touch buttons

10)Linear scale Grating space: 0.04mm,0.02mm, 0.01mm,power supply is +5V.the difference between two and four TTL output signal is 90°.

D60 digital readout  Function introduction

1)Circular drilling function: Digital readout can automatically calculate the location of the hole according to the inputted data

2)Linear drilling function: Opposite to the axis of any angle, only the hole spacing remain fixed value, The DRO can calculate the location of the hole according to the inputted data

3)Tool radius compensation: In the use of cylindrical milling tool carrier, the tool radius must be taken into account. The direction of process will decide the increase or decrease of calculated value .Once the tool number is inputted, the DRO value will be saved.

4)Determine the workpiece center Only through the tool or touching the two points of workpiece, the DRO can calculate the workpiece center

5)200 sets tool base: while repeat the same process in the workpiece, you can store the tool value which will be convenience to the operator

6)Round arc processing: sample round processing and two axis arc processing

7)Function calculator: calculator function can improve operation efficiently

8)Slope calculation: input the two points of workpiece, the DRO can calculate the slope of the workpiece.

9)Z-axis combination calculation: Z-axis can display the combination displacement of two parallel axis

10)Preset value: preset the radius of workpiece

11)Linear scale error compensation or non-linear scale error compensation: compensation to ensure absolute precision and maximum efficiency. Multi-point compensation can reduce the machine error.

12)Numerical filtering function

13)EDM depth control: can assist tool make depth control efficiently