semi-automatic PET blow moulding machine

PET blow moulding machine semiautomatic

• Suitable for producing PET plastic containers and bottles in all shapes.
• Used to produce the carbonated bottle, mineral water, pesticide bottle oil bottle cosmetics, wide-mouth bottle and hot fill bottle etc. 
• Bottle size: from 100ml to 20L (depend on your requirements)

Main Feature of Machine

• Stable performance with advanced PLC. 
• Automatic preform conveyer to save human cost. 
• Preform self-rotation and infrared pre-heater revolution assure the even distribution of heat, which improve the bottle shaping rate, increase the production. 
• High adjusting performance to enable preheat the preforms perfectly by adjust the voltage control area in the PLC, which could adjust the temperature of the infrared lights in the pre-heater, and keep the proper temperature and humidity invariable. 
• High safeties with security automatic-locking device in each mechanical action, which will make the production into a perfect safe environment, in case of the breakdown in certain procedure. 
• Introduce the FESTO air cylinder to avoid contamination and noise. 
• Satisfaction with different atmospheric pressure for blowing and mechanical action by dividing the blowing and action into three parts in the air pressure diagram of the machine. 
• Strong clamping force with high pressure and double crank links to lock the mould. 
• Two ways of operating: automatic and manual. 
• Safereliable and unique design of the position of valve to make the pneumatic diagram in the machine easier to understand. 
• Low costhigh efficiencyeasy operation and maintenance etc, profited from the fully automatic technological process. 
• Ideal cooling system make the finished bottles without any flaws. 
• Easy for you to installtest and start up. 
• Low rejection rate: less than 0.2 percent.

Technique parameter:

Model	KM-A2
Productivity	Depend on bottle design	1800-2000PCS/H
Product type	Body diameter	20mm-100mm
	Height	50mm-350mm
	Neck diameter	15mm-38mm
Mold	Cavity	2cavities
	Mold thick	240mm
	Mold	500*500mm
Main machine power	Electrical source power	380v 3Phase /220v 3Phase  50/60HZ
	Rated Power	25kw
	Really use power	6kw
Air source	LP air compressor	1.0m3/min 1.0MPa
	HP air compressor	0.7m3/min 3.0MPa 2set
	Air dryer	1.0m3/min 3.0MPa 1set
Cooling water	Cooling water	10L/min
Size	L*W*H	1908*1280*1920mm
	Weight	2000kg
Auxiliary equipment(preform unscrambler)	L*W*H	2000*950*2480mm
	Weight	250kg
Resin available		PET

 

Main part:
Pneumatic part	Valve	SMC
	Cylinder
Electric part	PLC	LG Mitsubishi
	Operating system	LG /HITECH
	Relay	OMRON
	Infrared thermometer	America raytek
Note	All of the electrical components adopts CEULCCC approved international advanced high-tech product.

 

 

Factory Image Show