Variable Rake Angle Hydraulic Shears

• The stable robust, all welded steel frame from ultrasonically tested plates are of top quality. Ram
  and table designed with special inclined member and box type structure for maximum strength.
  
  
• The top beam is guided by three point roller with replaceable hardened liners for least wear.This eliminates lubrication of guides. Roller guide made of hardened & ground bearing steel to provide better quality of cutting for a long time.
  
  
• Rake angle can be varied to permit shearing of higher thickness than nominal capacity and facilitating distortion free shearing of thin sheets.
  
  
• The fastest and easiest way of blade clearance setting without need of feeler gauge, which helps 
  Burr-free edges.
  
  
• Positive holding by hydraulic holddowns before shearing avoids slippage of sheets and independent       operation of holddowns for clamping of sheet helps checking of mark without taking shear stroke.
  
  
• Front gauging by disappearing stoppers mounted on left squaring arm. Robust, heavy & accurateback gauging to set cutting width.
  
  
• Hydraulic cylinder are designed with both low and high pressure sealing, Hard chrome plated rod also with special type guide for long life without leakage.
  
  
• Hydraulic components of international quality assembled in our own factory with specially designed compact manifold

• Main Drive motor
• Electric Control Panel
• Operational Console
• Pre selector switch to adjust rake angle  
• Lever operated blade clearance with calibration
• Fine stroke adjustment rod with limit switch
• Front sheet support 
• Squaring arm on right end with steel rule
• Hardened transfer bar mounted on table 
• Hold down cylinders  
• Shadow light Indicator
• Four edge HCHCR / HCSR blade interchangeable & suitable to shear mild and St. Steel
• Manual back gauge

OPTIONAL ACCESSORIES

• Second squaring arm on left side
• Motorised back gauge with DRO
• NC back gauge with ball screw
• Front support with rolleraccording to required length
• Rear sheet support
• Ball transfer table
• Degree protector for angular cutting
• Stroke counter
• Design with throat depth
• First fill of hydraulic oil