digital plug in timer

digital plug in timer

1,Main technical parameter

Timer setting

1.Make sure the time on (timer controller) display is same as local time, for re-calibration, push down the "clock" key while press down the school "week", "Hour", "Minute" key, to make time change to accurate time;

2. Press  the "Settings" button, till the  left display appear "1 on" word (for the first time on time). "When" and then press the "week" Select five-day work, the same day, different daily work mode, press the "points" button, enter the desired time of opening;

3. Press the "Settings" button, the display appears the bottom left of the word "OFF 1" (indicating the first off-time), and then "week", "Hour", "Minute" key, enter the desired closure date (Note: be sure to turn off the date corresponds to the date and open) and time;

4. Continue to press  the "Settings" button, on left of the display will show "2 open, 2 off, 3 on, 3 off, ......, 16 open, 16 off", take reference of step 2 and 3  to set the next time switching in need.

5. If do not need to set total 16 group switches,  must press the "Clear" button, so the left timer switching will be deleted. Make  it appears on the display "-: -" pattern (not 00:00);

6. After the timer is set up, press the "Settings" button to check the timing of each sub-set is consistent with the actual situation. If not, please press school, school division, school week to adjust or reset;

7. Press the "On / Auto / Off" button will display the word symbol transferred to the bottom of the "automatic" position, this time, when the control switch to open automatically according to the set time, turn off the circuit. As required in the course of the temporary opening and closing the circuit, simply press the "On / Auto / Off" key symbol transferred to the corresponding word "on" or "off" position.