Armouring Cable Galvanized Iron Wire 4.11mm

Specifications

Armouring Cable Galvanized Iron Wire 4.11mm
1.Tensile Strength:390Mpa-500Mpa
2.Zinc Coated: min 45g/m2
3. Coil Pack
4. Cabl

Armouring Cable Galvanized Iron Wire 4.11mm

 

Iron Wire is a soft, heavily Zinc coated wire used in the power, terrestrial and marine communications industry for binding electrical cables which are used in places where the cable maybe subjected to crushing or other injury. 

Low carbon armouring wires are produced to meet the requirements of Australian Standard AS 3863 "Galvanised Mild Steel for Armouring Cables"; BS EN 10244 etc. High carbon armouring wires can be produced to customer requirements on request. 

Armouring wire is available in diameters ranging from 0.9mm to 8.0mm and is available in either coils or stems.

1)  Wire Specifications

Diameter Tolerances
 

 

Nominal Wire Diameter	Tolerance (mm)
over 0.15mm up to and incl. 1.60mm over 1.60mm up to and incl. 2.50mm over 2.50mm up to and incl. 4.00mm over 4.00mm up to and incl. 5.00mm over 5.00mm up to and incl. 8.00mm	+/-0.03 +/-0.03 +/-0.03 +/-0.04 +/-0.04

 

Galvanised Coating Weight - AS3863; EN 10244

 

Wire Diameter	Minimum Ctg Mass (g/m2)
over 0.15mm up to and incl. 1.60mm over 1.60mm up to and incl. 2.50mm over 2.50mm up to and incl. 4.00mm over 4.00mm up to and incl. 5.00mm over 5.00mm up to and incl. 8.00mm	25 45~200 45~620  45~820  45~820

 

Tensile Strength (MPa)

The tensile strength is defined as the maximum load achieved in a tensile test divided by the cross sectional area of the wire test piece. The tensile strength range for mesh Wire is 350 to 500 MPa.

Steel Chemistry

The table below is indicative of steel chemistries used for low carbon Armouring Wire.

 

Element	%
Carbon Phosphorus Manganese Silicon Sulphur	0.05 max 0.03 max 0.50 max 0.12/0.18 0.30 max

 

 

 

 Quality Control:

 

Total quality control. Every pieces of the raw material; semi-finished products and finished products are tested and recorded in file. The tracking record is used from final products to the very first beginning raw material steel factories.

 

Third Part like SGS is available for test control before shipment

 

Sales Territory:

 

South America; North America; South Korea; Australia, Europe; Middle East; etc