Dramix 3D Concrete Steel Fibers in MALAYSIA

Item Name: Low Carbon End Hook Steel Fiber 

Company introduction:

Chongqing Joywell Trade Co.,Ltd is an professional foreign trade company which was founded in 1999. We are on the market of building materials more than 14 years, obtained a good feedback both in domestic and overseas. There are kinds of steel fibers: melt extract stainless steel fiber, hooked ends cold drawn steel fiber, crimped steel fiber, cutting steel fiber, cutting micro steel fiber, copper coated steel fiber etc. Should you have any interests or suggestions, pls don’t hesitate to contact us directly.

What’s steel fiber?

Steel fibres are filaments of wire, deformed and cut to lengths, for reinforcement of concrete, mortar, cement slurry and other composite materials. They have anti-crack, anti-bend, anti-wear, anti-shear, anti-twist, anti-fatigue,stretching resistance, abrasion resistance characters. Widely be used in industry, military,construction, machinery, metallurgy, petrifaction, pottery areas.

Wide range of applications:

Highway pavements/road overlays       Airport runways and taxiways           Bridge/tunnel/mine

Composite metal decks                        Equipment foundations                    Concrete/shotcrete

Blast resistant structures                      Hydrodynamic structures                 Railway sleeper

Industrial ground floor slabs                 Dam and stabilization                       Spray anchor

Commercial and residential slabs         Shock resistance structure              Cemetery/cesspool

Army construction                                 Mix with refractory                            Seismic design

How to use?

1.To put steel fiber and mixing stuff into mixer to mix 30---60 seconds, the steel fiber will distribute equally in mixing stuff to avoid agglomerate.

2.Then to put sand and concrete into mixer to mix 30—60 seconds.

3.Finally to add water into the mixer to turn and mix 2-3minutes.

4.To transport them to working place.

Caution:

To minimize the risk of minor injury when handling or finishing mixes containing steel fibers, gloves should be worn. Gloves of similar quality to those normally worn by concrete placing and finishing crews are adequate. The use of gloves and eye protection during loading of steel fibers to mixer is recommended.