Basement waterproofing membrane

1. Preparation

Denso Flashing Tape must only be applied to clean dry surfaces.  Remove all loose dust and dirt with a wire brush and soft broom from the area  of application.

2. Application

a.) Measure length of Denso Flashing Tape required and cut from the roll.

b.) Peel a short length (about 4 inches) of the release film from one end of the length of tape.
c.) Position this end (compound side down) onto the dry primed surface and press down firmly with hand or roller.

d.) Ensure the tape is evenly pressed down avoiding creases or air pockets.  It is very important to press down the edges and ends of the tape.

e.) Continue along the length of tape peeling off approximately 8 to 12 inches of release film as     application proceeds.  It is recommended that only short lengths of release film are removed           at any time to avoid contamination of the compound with dirt and dust.

 It can be used for  Doors & Windows , Roof Patch ,Gutter Patch, Skylights, Valley Repair ,Metal Patch Metal Roofs, Flat Roofs, Trucks, RV’s ,Mobile Homes, Trailers.

Besides ,it also could be used for  Exposed steel pipelines