1/2BA-309SS25,25 nozzle,BA offset-type hollow cone nozzle

1/2BA-309SS25,25 nozzle,BA offset-type  hollow cone nozzle 

【YBS Nozzle】offer 1/2BA-309SS25,25 nozzle,BA offset-type  hollow cone nozzle and other products.Tel:86-0769-

81609791

In some chemical plant, BA offset-type nozzle is used to sulphur burning. Offset-style for  installation with physical space 

limitations.With 40ml cleaning fluid every 10 minutes , a total of 3 to 4 times.4 . Reconnect after cleaning the ink supply tube 

and liquid level sensor signal line , and then continue the previously paused print job .Five . The above approach is not 

effective treatment or no effect when

1 . The hollow cone nozzle from the hollow cone nozzle to remove the tray removed .

2 . In a clean glass container : Pour the amount of cleaning fluid ( eg beaker ) in order to put a hollow cone nozzle 

submerged at the bottom of a hollow cone nozzle 2 ~ 3mm is appropriate, then a glass container with plastic wrap to seal the 

( anti-gray ) stand for more than one day .Note : Hollow cone nozzles do not touch the top of the Signal Interface cleaning 

fluid , otherwise it will damage the hollow cone nozzle .

damage to the hollow cone nozzle .

NOTE: Continuous use cleaner to clean without over three times.

4 . 40ml glass syringe to extract special cleaning fluid, ink tube from a hollow cone nozzle interface inside the upper part of 

the injection nozzle to observe the waterline from the state , if all the waterline are straight , indicating effective cleaning , this 

hollow cone nozzle can continue to use ( premise : circuit piezoelectric crystals are intact ) , if there are still some waterline 

spray crooked , you are required to do steps 2 and 3 2 to 3 times .

VI. Treatment device is expected to be more than 48 hours when not in use

If the device is expected to be more than 48 hours is not in use , it must be hollow cone nozzle ink clean, otherwise the ink 

nozzles because of the gradual evaporation of the solvent and dry, serious even be irreversibly damaged nozzles . Process as 

follows:

1 . Turn off the power inkjet printers .

2 . Clean the head to the extreme left position , at the bottom of a hollow cone nozzle to put a corrosion-resistant container 

for containing cleaning liquid .

3 . Glass syringe out or poured directly in the ink sub tank , then use special cleaning fluid to the sub tank clean.

4 . The hollow cone nozzle ink supply tube on ( from the sub tank ) pulled out , and then extract 40ml glass syringe with a 

special cleaning fluid to clean hollow cone nozzles were done twice. Finally, do not put a hollow cone nozzle cleaning fluid 

residues blown clean , be sure to stay inside the hollow cone nozzle , because the cleaning fluid nozzle can play a 

moisturizing effect on adequate cleaning fluid.

5. The hollow cone nozzle processed into a clean container and sealed corrosion ( with plastic wrap on the good ) can be 

stored up after a month or so.

The removable cap and NPT or BSPT thread.

Ordering information of 1/2BA offset-type  hollow cone nozzle(YBS brand)

Materials：None=brass

SS=303 stainless steel

309SS=309

stainless steel

 1/2 1/2BA-25 1/2BA-I25 1/2BA-309SS25

1/2BA-30 1/2BA-I30 1/2BA-309SS30

1/2BA-40 1/2BA-I40 1/2BA-309SS40

1/2BA-50 1/2BA-I50 1/2BA-309SS50

1/2BA-60 1/2BA-I60 1/2BA-309SS60