DEIF DU-2MKIII

Brand: DEIF

Type:DU-2MKIII

Origin: the United States

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

Module of PLC, DCS, ESD system card, the card is a vibration monitoring system, steam turbine control system module, the advantages of the gas generator spare parts brand: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts of our products are widely used in metallurgy, petroleum, glass, aluminum manufacturing, petrochemical industry, coal mine, papermaking, printing, textile printing and dyeing, mechanical, electronic manufacturing, automobile manufacturing, plastic machinery, electric power, water conservancy, water treatment/environmental protection, boiler heating, energy, power transmission and distribution and so on.

The following are optional parameters that can be set. Parameter Function EncOut Sets the line count of the emulated encoder output. EnInhibitCW EnInhibitCCW Enables the hardware over travel limits.

SFD Position Mode The base S200 can drive a motor in Position Mode using SFD Feedback. The source of the command can either be Step and Direction, or A,B differential quadrature signals. The drive needs to be configured using the S200Tools utility. The configuration parameters should be saved to non-volatile memory (click the NV Save button) to allow the configuration to be recalled on power up. To configure the drive for SFD feedback set the following parameters: Parameter Value CommMode SetupS2-2 (Default value) with switch S2-2 set to the down position labeled, S on the drive. or SFD CommOff 0 Degrees – for AKM motor series. Check with your sales representative for the correct commutation offset angle for other motor series. OpMode Position PosCmdSrc Selects the source of the command, either Step-Dir or AquadB. GearIn GearOut Sets the distance the shaft moves for each input position command pulse/count. KPP Sets the proportional gain of the position loop. KVFF Sets the feed forward gain of the derivative or the position command to the internal velocity command. 

SelSFDParam SFD (Default value) – recommended setting This setting will automatically set the motor parameters. KVP will be set for 75 Hz nominal velocity loop bandwidth with an unloaded motor. To change KVP or other motor parameters refer to Configuring with SFD Feedback Motor Parameters. KVI Sets the velocity loop break out frequency from integral to proportional compensation. ARF0 ARF1 Single pole filters in the velocity loop forward path. Set to accommodate the effects of mechanical resonance. The following are optional parameters that can be set. Parameter Function EncOut Sets the line count of the emulated encoder output. NOTE: Emulated Encoder Outputs are not available when the PosSrcCmd is set to AQuadB. EnInhibitCW EnInhibitCCW Enables the hardware over travel limits